- ページ 3

スイッチ Bender ATICS DIO SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Bender ATICS DIO Series 13 ページ。 Automatic transfer switching devices for safety power supplies

ページを印刷する

Removing the terminal covers

Mounting the ATICS® on DIN rail

ATICS-DIO_D00080_02_Q_XXEN/04.2017

Push back the locking hook (B) in the middle of the top and

bottom terminal cover (A) by using a screwdriver.

Remove the terminal cover.

Place the ATICS® on the top edge of the rail.

ATICS-2-DIO: Use a screwdriver to pull down the lower yellow

slide lock (C) and snap the ATICS® into place with slight pres-

sure.

ATICS-4-DIO: Remove bottom green plug connector. Use

screwdrivers to pull down the two lower yellow slide lock (C)

and snap the ATICS® into place with slight pressure.

Check that the slide locks are properly snapped into position

by pulling slightly the lower part of the enclosure.

Secure all terminals including the unused terminals with Allen

screws.

Tightening torque: 5 Nm.

Fasten the terminal covers.

Tighten the mounting screws (D) (PZ1, 8.8 lb-in, 1 Nm).

Caution: If the screws are not tightened, ATICS® can be dama-

ged by the vibrations of the switch-over.

ATICS-...-DIO Quick start