- ページ 6
自動車部品 BENDIX MC-11 TRACTOR ANTILOCKのPDF マニュアルをオンラインで閲覧またはダウンロードできます。BENDIX MC-11 TRACTOR ANTILOCK 20 ページ。 Tractor antilock
ページを印刷する
INLET SOLENOID
RESERVOIR
FIGURE 6 - ANTILOCK MODE: SOLENOIDS ACTIVATED
3. With the brake application held and a technician near
the modulator, turn the vehicle ignition key to the ON
position. One short burst of air should be noted from the
modulator exhaust. If one short burst of air is not noted,
or if the exhaust is prolonged and not short, sharp and
well-defined, refer to the troubleshooting section.
WARNING! PLEASE READ AND FOLLOW
THESE
INSTRUCTIONS
PERSONAL INJURY OR DEATH:
When working on or around a vehicle, the following
general precautions should be observed at all times.
1. Park the vehicle on a level surface, apply the
parking brakes, and always block the wheels.
Always wear safety glasses.
2. Stop the engine and remove ignition key when
working under or around the vehicle. When
working in the engine compartment, the engine
should be shut off and the ignition key should be
removed. Where circumstances require that the
engine be in operation, EXTREME CAUTION should
be used to prevent personal injury resulting from
contact with moving, rotating, leaking, heated or
electrically charged components.
3. Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended
procedures. Use only the proper tools and observe
all precautions pertaining to use of those tools.
6
EXHAUST
SOLENOID
SUPPLY
EXHAUST
TO
AVOID
DOUBLE
CHECK VALVE
BRAKE
VALVE
CONTROL
PISTON
DELIVERY
BRAKE
CHAMBER
4. If the work is being performed on the vehicle's air
brake system, or any auxiliary pressurized air
systems, make certain to drain the air pressure from
all reservoirs before beginning ANY work on the
vehicle. If the vehicle is equipped with an AD-IS
air dryer system or a dryer reservoir module, be
sure to drain the purge reservoir.
5. Following
the
recommended procedures, deactivate the electrical
system in a manner that safely removes all
electrical power from the vehicle.
6. Never exceed manufacturer's recommended
pressures.
7. Never connect or disconnect a hose or line
containing pressure; it may whip. Never remove a
component or plug unless you are certain all
system pressure has been depleted.
8. Use only genuine Bendix
components and kits. Replacement hardware,
tubing, hose, fittings, etc. must be of equivalent
size, type and strength as original equipment and
be designed specifically for such applications and
systems.
9. Components with stripped threads or damaged
parts should be replaced rather than repaired. Do
not attempt repairs requiring machining or welding
unless specifically stated and approved by the
vehicle and component manufacturer.
10. Prior to returning the vehicle to service, make
certain all components and systems are restored
to their proper operating condition.
TRAILER
CONTROL
VALVE
vehicle
manufacturer's
replacement parts,
®
™