- ページ 9

GPS Bendix/King Skymap IIICのPDF パイロット・マニュアルをオンラインで閲覧またはダウンロードできます。Bendix/King Skymap IIIC 14 ページ。 Global positioning system
Bendix/King Skymap IIIC にも: マニュアル (6 ページ), クイック・リファレンス (6 ページ)

Bendix/King Skymap IIIC パイロット・マニュアル

Semi-Duplex Programming

This is available if the semi-duplex option was enabled during installation.
Different transmit and receive frequencies (semi-duplex) may be programmed into
every channel except the Guard. If semi-duplex operation is desired, then perform
the following steps:
Press and hold the CHAN button for at least three seconds. The top dis-
play line will flash P01 indicating the programming mode is active on
channel 1.
Rotate either the small or the large Frequency/Channel Select Knob to
change the channel number.
Momentarily press the MODE button, the frequency display begins to
flash.
Rotate the knobs to select the desired transmit frequency, refer to the
Entering a Manual Frequency section (if the channel is not programmed,
the large knob will need to be turned first).
Momentarily press the PUSH TONE button to select this frequency as the
transmit frequency.
Rotate the knobs to select the desired receive frequency, refer to the
Entering a Manual Frequency section (if the channel is not programmed,
the large knob will need to be turned first).
If more channels need to be programmed, press the MODE button and
repeat this procedure.
Press the CHAN button or wait ten seconds to exit the programming
mode.
This channel has now been programmed with different transmit and receive
frequencies.

Semi-Duplex to Simplex Conversion

To convert a semi-duplex channel to simplex (transmit and receive frequencies are
the same), perform the following steps:
Press and hold the CHAN button for at least three seconds. The top
display line will flash P01 indicating the programming mode is active on
channel 1.
Rotate either the small or the large Frequency/Channel Select Knob to
change the channel number.
Momentarily press the MODE button, the frequency display begins to
flash.
Rotate the large Frequency/Channel Select Knob until the display shows
dashes (between 399 and 225).
Momentarily press the PUSH TONE button.
Press the CHAN button or wait ten seconds to exit the programming
mode.
The former receive frequency is now the transmit and receive frequency.
7