産業機器 dymax BlueWave 200のPDF クイック・スタート手順をオンラインで閲覧またはダウンロードできます。dymax BlueWave 200 2 ページ。 Handheld diaphragm valve
dymax BlueWave 200 にも： ユーザーマニュアル (16 ページ), クイック・スタート手順 (2 ページ), クイック・スタート手順 (2 ページ), クイック・スタート手順 (2 ページ)
ページを印刷する1.
Remove the protective cover from the Lightguide Mount.
2.
Insert the large end of the Lightguide into the Lightguide Mount until it snaps into place (Figure 1). Fasten the Lightguide into place by
lightly tightening the Setscrew located on the Lightguide Mount (Figure 2). A Hex Wrench is provided with the system for this purpose. The
Setscrew should be tightened gently to prevent damage to the Lightguide.
NOTE: Multi-Leg Lightguides should be balanced by rotating the Lightguide to obtain the desired UV intensity of each leg before lightly
tightening the Setscrew.
Figure 1. Insert Lightguide into Lightguide Mount
3.
Connect the Power Cord to the Power Receptacle on the rear of the BlueWave 200. Plug the Power Cord into a grounded wall outlet.
4.
If you will be using a Foot Pedal, connect the Foot Pedal to the Foot Pedal Connection (Figure 3) on the rear of the unit. A ground stud is
also provided on the back of the BlueWave 200 if additional grounding is desired.
5.
Turn the Power Switch on (located on the rear of the unit) and press the "Bulb On" button (Figure 4). Allow the Bulb to warm up for 5
minutes.
6.
The unit is ready for operation. The Shutter is opened and closed by means of the Foot Pedal.
Figure 3. Rear Connections
BlueWave
®
Quick Start Instructions
200 Version 3.1
Figure 2. Gently Tighten Setscrew on Lightguide
Mount with Hex Wrench
Figure 4. Front Panel Controls