- ページ 10

照明器具 dymax PC-3のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。dymax PC-3 16 ページ。 Ultra uv curing light source
dymax PC-3 にも：操作マニュアル (20 ページ)

LAMP REPLACEMENT/INSTALLATION

BEFORE REPLACING THE LAMP, THE UNIT MUST BE "OFF" FOR A MINIMUM OF 5

MINUTES.

THIS WILL ALLOW DANGEROUS CHARGES, WHICH ARE PRESENT FOR

PROPER LAMP OPERATION, TO BLEED OFF.

LAMP REPLACEMENT MUST BE EXECUTED BY THE TRAINED SERVICE

LAMP REPLACEMENT PROCEDURE

1. Allow the unit to cool before removing the lamp/reflector assembly.

2. You must unplug the power cord.

3. Loosen the top housing by removing the top four thumbscrews and slightly loosening the

bottom four. Tilt the cover back to access bulb.

4. To remove the old bulb: A) remove the positive electrode wire from electrode board (see

Figure 1.1).

Do not disconnect the wire from lamp. B) Gently lift the brass negative

electrode while lifting the bulb/reflector out.

5. To install a new bulb, simply reverse the steps followed in #4 above. Gently lift the brass

negative electrode while positioning the bulb/reflector in the reflector mount.

6. Attach the electrode wire to the positive electrode board (see Figure 1.1).

7. Close the top housing and tighten all screws.

8. Record the serial number of the unit and hour-meter reading on the Bulb History Record and

return to Equipment Customer Service.

TM-023 PN 37099

Rev 05/12/98

WARNING

PERSONNEL ONLY!

Figure 1.1