- ページ 10

ラック＆スタンド GABOR FSM-XのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GABOR FSM-X 16 ページ。 Full swing mount for large and extra-large flat-panel displays

Attaching the Wall Bracket to Concrete

Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick.

If the concrete exhibits cracks or other defects, this may result in failure of the

concrete anchors and cause serious personal injury or damage to your display.

Place the wall bracket template

up to the marked locations, and

tape it to the wall. Use the

provided bubble level to make

sure the template is level before

drilling. Use a pencil to mark the

six locations as shown, and place

a piece of tape over each mark.

Use a 1/2-inch (12 mm) concrete

drill bit to predrill the marked

spots 3.7 inches (95 mm) deep,

and then clean out the debris

from the holes.

1/2 in.

3.7 in.

Remove the template,

and insert the concrete

anchors into the predrilled

holes. Use a hammer to

tap the anchors into the

concrete.

Screw in the top two

anchor screws that

correspond to the wall

bracket's seating holes,

and leave a 5 mm gap

between the wall and the

screw's head.

5 mm