- ページ 9

ラック＆スタンド GABOR Mainmast DMS-200のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GABOR Mainmast DMS-200 13 ページ。 Single display desktop monitor stand for 17 to 32 in. screens

ページを印刷する

Mounting the Monitor

Before you attach the VESA plate, hand thread one of the M-A or M-B screws to determine

which one fits your monitor. Make sure the screw is also not too long or too short. If the

screw is too long, it may damage the display. If it's too short, it may not hold it.

100 × 100 VESA Pattern

Slide M-C washers onto two

screws, and thread the screws

into your monitor's top two

VESA holes. Leave about 3

mm between the washers and

the monitor.

Hang the monitor on the VESA

plate's two top notches with

the two installed mounting

screws.

Important! The washer should be

between the screwhead and the

VESA plate.

Slide M-C washers onto two screws, and thread the screws into the bottom two VESA holes.

Use the 5 mm hex key (K) to tighten all four screws until snug. Do not overtighten.

75 × 75 VESA Pattern

Thread two screws into your

monitor's top two VESA

holes. Leave about 3 mm

between the screws and the

monitor.

Hang the monitor on the

VESA plate's two keyholes

with the two installed

mounting screws.

Important! Do not use washers for

the top screws on the 75×75 VESA

pattern.

100

VESA

75 100

PATTERNS

M-A

M-B

M-C

3 mm