- ページ 5

録音機器 Benedini TBS Micro V2.0のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Benedini TBS Micro V2.0 9 ページ。

Direct

2.2.

sound selection by a 3 position switch (toggle switch)

If you want to run only the engine sound and ONE special sound (f.e. MG), you can use this

simple control mode.

You need a proportional channel equipped with a 3 position switch with neutral position and

momentary contacts to both sides or a common joystick channel.

A attached servo must leave its middle/neutral position when the switch is pressed in one

direction and must return to its middle position when the switch is released. Pushing the switch in

the opposite direction causes the servo to move to the other side.

Please compare the very left and right positions of the servo with a common joystick channel.

They should be about the same.

This is the first test you should do before programming the sound unit.

The control channel must be connected to

Teaching the direct sound selection

(similar to Autostart mode)

1. Power on transmitter and receiver. LED blinks fast -> normal mode

Bring throttle stick to idle. Motor must not move.

2. Bridge LRN contact for about 0.5 seconds until beep -> LED cont. on.

At this moment the idle position of the throttle stick is stored.

3. Move throttle stick to your desired acceleration point (throttle stick position where idle

dead band stops and engine running sound starts) and wait for a beep

Now the dead (neutral) band of the speed channel is defined.

4. Move the throttle stick to full speed position and wait for three beeps.

After this the sound unit is back in the normal operation mode.

If you leave the last stored throttle stick position, a very short beep is played. Since then,

you have about 2 seconds to adjust the new throttle stick position to be stored next.

Soundmodule TBS Micro V2.0

Prop2

of the TBS Micro.

Page:5