- ページ 6

リフティングシステム Active Mobility NEOS 150 FoldingのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Active Mobility NEOS 150 Folding 20 ページ。 Mobile patient lifting hoist

ページを印刷する
Active Mobility NEOS 150 Folding ユーザーマニュアル
ASSEMBLY INSTRUCTIONS
Folding
The ALLEGRO range of patient lifting and transfer hoists are fully
assembled, load tested and certified at the factory before being partially
dismantled for packing and shipping.
Use the instructions below as a guide to assemble your
Folding
hoist .
1.
Remove lifter components from protective packing and lay out
on a smooth surface to prevent damage to powder coating on
lifter sub assemblies.
2.
Lift the mast assembly and slide into mast holder receiving
socket on base chassis. Ensure the mast assembly is
completely engaged in the mast socket. Insert the locating bolt
through the chassis and base and tighten the locking levers to
prevent movement between mast and base chassis.
3.
Attach lift actuator to jib, by aligning actuator clevis with actuator
mount bracket. Insert bolt and tighten nylock nut.
4.
Attach push handle assembly with bolts supplied with handle
assembly.
5.
Attach battery by clipping battery pack on top of control box.
6.
Plug the lift actuator cable into port 1 positioned on the
underside of the control box, ensuring it is driven firmly home in
the socket.
NEOS 150 Folding
7.
Your
adjustment via a foot pedal. This leg adjuster does not need any
further assembly.
8.
Plug the handset lead into the large socket on underside of
control box. (See next diagram) ensure alignment of tongue on
handset plug with groove in control box handset connection
port. When aligned press home firmly. A smear of Vaseline on
the o ring may assist if plug is tight.
9.
Check operation of lifter via handset, ensuring that the RED
EMERGENCY STOP BUTTON ON THE CONTROL BOX IS
RELEASED. Turn the knob quarter turn clockwise to release.
NEOS 150 Folding User Manual
Doc Neos 1.1
NEOS
NEOS 150
hoist uses a manual leg
150
| 6