- ページ 7

ターンテーブル Gadhouse MATHISのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gadhouse MATHIS 12 ページ。

ページを印刷する

GETTING STARTED

INITIAL SETUP

1. Place the unit on a ﬂat and level surface. The selected location should

be stable and free from vibration.

2. Install the turntable lid to the hinges.

3. Remove the tie-wrap that is holding the tonearm.

4. Put the drive belt around the Turntable Hub, and then use the provided

belt hoot to help pull the belt to ﬁt around the slot of motor pulley.

5. Place the turntable platter through the turntable spindle.

6. Place the slip mat on top of the turntable platter.

7. Slide Tonearm Counterweight onto tonearm and twist it lightly onto the

rear shaft of the tonearm.

8. Adjust the counterweight to set proper stylus pressure.

9. Connect the adaptor to the Power Jack of the unit.

NOTE: Do not plug the AC power adaptor to power outlet before all the

assembly is completed. Before turning the power on, make sure again all

the connection setting are correct. Always turn off the power when

connecting or disconnecting.

CARTRIDGE DOWN FORCE ADJUSTMENT

The Counterweight supplied is suitable for cartridges weighing between

3.0-6.0g. Gently push and turn the Counterweight onto the rear of the

tonearm (with the scale facing toward the front of the turntable).

Remove the cartridge protection cap. Lower the tonearm lift and position

the cartridge in the space between tonearm rest and platter.Carefully

rotate the Counterweight until the tonearm balances out. The tonearm

should return to the balanced position if it is moved up or down.

This adjustment must be done carefully.

Counterweight

Downforce scale ring

Center line

Once the tonearm is correctly balanced return it to its' rest. Hold the

Counterweight without moving it, and gently rotate the Down force Scale

ring until the zero is in line with black line on the rear of the tonearm.

Check whether the arm still balances out.

Rotate the counterweight counter clockwise (seen from the front) to

adjust the down force according to the cartridge manufacturer's recom-

mendations. One mark on the scale represents 0.05g of down force.

NOTE: The recommended down force for the factory ﬁtted cartridge is

1.8-2.2g (Model: AT-VM95E)

ANTI-SKATE FORCE ADJUSTMENT

The anti-skating force must be adjusted corresponding to the tracking

force as follows:

Tracking Force

Groove in the stick

5-10 mN

1st from bearing ring

10-15 mN

2nd from the bearing ring

15-20 mN

3rd from the bearing ring

20mN and bigger

4th from the bearing ring