- ページ 5

錠前 Adel Trinity 788のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Adel Trinity 788 12 ページ。 Biometric fingerprint door lock
Adel Trinity 788 にも：操作マニュアル (12 ページ)

ページを印刷する

Trinity 788 Operation Manual

Specific operations:

a) Press the on battery cover button, slide the battery cover upward and remove it, you can see

one hole at each side, and inside each hole there is a button for setup;

b) Remove either of the four batteries, pressing the buttons on the front side to confirm the power

is successfully cut off, then insert into the two holes to press the buttons inside with two slim

objects (e.g. iron wire) at the same time, hold it tight (not to release), and reload the battery. The

lock is then re-powered, if you hear a toot sound after 5 seconds, the initialization of the lock is

successfully completed, and you may loose the slim objects.

Note:

After initialization of the lock, all the enrolled fingerprints and password in the lock are cleared,

and the lock resumes to the new lock state (factory setting). Any finger can open the door, and

master fingerprints, member fingerprints, as well as spare passwords need to be set again.

Trinity 788 Operation Manual

III. Enrollment of master fingerprints / member fingerprints

Enrollment of master fingerprints (take user

Operational procedure

In the state of new lock, put any finger on the fingerprint

collection window to enter the door open state

Press Button +

to enter the enrollment mode

Press Button + or - to adjust the first digit 0 of the

fingerprint code, and press Button # to confirm the choice

Continue to press Button + or - to adjust the second digit

1 of the fingerprint code, and press Button # to confirm

Press Button

to reconfirm

the fingerprint code 01

Put the finger to be enrolled on the fingerprint

collection window, and collect twice

The first master fingerprint is set

as an example)

Indication of the lock

Green light is on, and the LED displays

A beep sound heard, and the LED displays

The tens place displays the figure that has just

been set, while the ones place displays

The LED displays the fingerprint

code

flashing

The LED displays fingerprint code

01 ,

with red light on the fingerprint window

When the red light of the fingerprint window is on,

press with the finger; after the beep, remove the finger

and press one more time. A long beep will sound and

the two collections are successfully completed

The LED displays the code

and enrollment

finished. Light on fingerprint window turns off and the

LED displays 0- ,continue to set other fingerprints