- ページ 5

高圧洗浄機 Active Products YE03のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Active Products YE03 10 ページ。 1450 psi electric pressure washer

ASSEMBLY AND OPERATING INSTRUCTIONS

Surface Preparation

Before starting any cleaning task, it is important to inspect the area for objects that could

create a hazard. Remove any objects from the work area that could be tripped over, such as

toys or outdoor furniture. Ensure that all doors and windows are closed tightly.

Water Supply (Cold Water Only)

Only draw water through the unit. For use with cold water supply only. Water hose must be

at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM

(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running

the water for one minute into an empty 5-gallon (19 L) container.

CAUTION

• Never use the pressure washer to draw in water contaminated with solvents (e.g.

paint thinners, gasoline, oil, etc.).

• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking

the water filter (located inside the water inlet. To clean it out see Maintenance section).

• Always prevent debris from being drawn into the unit by using a clean water source

and an additional accessory water filter if required.

• To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.

Attach high pressure hose to the machine's water outlet

(hand tighten only).

ASSEMBLY AND OPERATING INSTRUCTIONS

Attach high pressure hose to the gun assembly

(hand tighten only).

Attach the inlet adapter to the machine's water inlet.

Hand tighten only. (Some models come with inlet

adapter pre-assembled. Check your unit.)

Attach quick connect coupling to garden hose (hand

tighten only) and attach to inlet adapter.

Insert choice of wand to the gun and twist

¼ turn to lock in position.