ページを印刷するon/off.
5. Matters needing attention：
5.1 The function will only work normally in proper working power conditions.
5.2 Control box input voltage must be less than 29.2VDC.
5.3 The CH18 remote control is needed for proper control.
5.4 If problems are identified, they must be treated by professional personnel.
6. Additional attention for user：
6.1 This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.
6.2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
6.3 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure compliance requirements, please
using a minimum separation distance of 5 mm from the device.
This transmitter must not be co‐located or operating in conjunction with any other antenna
or transmitter.
6.4 For Intentional and unintentional radiators the manual shall caution the user that changes
or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment
3/3