- ページ 15

スイッチ 5Gstore EZ-62BのPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。5Gstore EZ-62B 15 ページ。 Single outlet remote power switch

Upgrading Firmware :

Firmware can ONLY be done using the iOS/Android application, while on the local

network. Firmware cannot be downgraded or upgraded to a specific version. When

upgrading, it will automatically upgrade the outlet to the most current version of

firmware.

1. Open the ezDevice app and select your EZ-62B from the list

2. On the next screen, select More from the bottom right

3. Select Device Upgrade from the next screen

4. Your EZ-62B should be listed here (along with any others you have saved).

NOTE: If you don't see your EZ-62B listed, click the Search in LAN button. If the

app still cannot locate your EZ-62B, click Manual Upgrade at the top

5. Once an outlet is selected, a pop up will appear indicating the Version it will

upgrade to, along with the steps listed below. NOTE: If your outlet was NOT

found, you will need to manually enter the Device's IP address

a. Write down device LAN IP (for recovery)

a. All settings will reset to default. Go to device's LAN interface to save

settings

b. Device will reboot after upgrade

c. Red light flashes while loading/ upgrading then goes solid before the

sequence below occurs

d. LED sequence during firmware update: Internet & Auto Reset LEDs will

blink

e. Device clicks and reboots and you get indication that upgrade successful

6. Click Yes to begin the upgrade process.

7. You should first see a pop up showing Upgrading with a spinning wheel,

followed by a progress bar

8. The upgrade takes about 1-2 minutes and once finished, you'll see an OK button

How to Remove Users and Reset Using Function Button

1. Press and hold the Function button for 10 seconds. The Internet and

Cloud Link LEDs will blink. Release the button.

2. Log into your Cloud4UIS account and Remove the EZ-62B from the

Device List. Via the mobile app - look for Remove Device at the top. Via

Cloud4UIS.com - look for the -Outlet button