- ページ 9

バーコードリーダー Adel BCRのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Adel BCR 14 ページ。 Barcode/contactless reader

ADEL S.r.l. – BCR Barcode / Contactless reader - User Manual Rev. 1.3

1 FLASH

2 FLASHES

3 FLASHES

4 FLASHES

5 FLASHES

7 FLASHES

8 FLASHES

6. PROGRAMMING PROCEDURE

For FW download, after setting dip 4-5-6 follow these instructions:

a. Connect serial cable to connector FLASHPRG (JST 4 P.M. a 90°).

b. Keep RESET button pressed and, at the same time, move the dipswitch 6 to On position; verify that

the DL4 led is on and release RESET button.

c. Execute the FUJITSU FLASH MCU Programmer program.

•

Select in the Target Microcontroller field the MB90F497/G model.

•

Select in the Cristal Fquency field the value of 4MHz.

•

Open the file with MHX extension.

•

Select the COM port to which the serial cable is connected.

•

The screen appears as the one on the button if the COM1 port is used.

•

Press the "Full Operation(D+E+B+P)" button.

•

When the Flash window appears press "OK".

•

Wait for procedure to finish.

d. At the end of the procedure press OK and close the program.

e. Select in the Target Microcontroller field the MB90F497/G model.

Press reset button and at the same time move the dipswitch 6 in Off position and verify that the LED

DL4 switches off. Release the reset button.

Command in execution

Command not executed for title not present in the module

Command not executed for title already present in the module

Command not executed for reading already enabled

Position error

Title jammed

Configuration not valid

pag. 9