- ページ 7

リベット工具 Gage Bilt GB206-500のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gage Bilt GB206-500 20 ページ。

When the tool is connected to a powerunit, operation is controlled by an actuator or switch attached to the hydraulic hoses. The

GB206-500A incorporates an air actuator to send a signal; the GB206-500 an electric actuator. When the button is depressed, a

directional valve in the powerunit directs oil to the front side of the piston forcing it and the nose assembly collet rearward. This

action causes the jaws to clamp on the fastener pintail and pull the sheets together. The anvil is forced over the collar, swaging it

into locking grooves of the fastener. Further force breaks the pintail off, approximately flush with the collar.

When the piston nears the end of its stroke it exposes flats on the back of the relief valve. These flats "dump" oil back to the powerunit

tank. When the button is released the directional valve reverses oil flow to the back of the piston and pushes the nose assembly off of

the swaged fastener. The spent pintail is released and drops out the back of the tool.

PULL Cycle

Piston Travel

PULL Pressure

GB206-500/ GB206-500A INSTALLATION TOOL

PRINCIPLE OF OPERATION

HYDRAULIC DIAGRAM

Relief

Valve

RETURN Pressure

Pressurized Oil

Unpressurized Oil

Images may not reflect actual tool

RETURN Cycle

Piston Travel

8/16 REV 4/23