- ページ 7

薪ストーブ Hi-Flame GloFire 737のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Hi-Flame GloFire 737 16 ページ。

Chimney connection

The chimney connector is a single walled pipe used to connect the stove to the

chimney. For use with the appliance the chimney connector MUST be 6" in diameter,

with a minimum thickness of 24 gauge black steel or 26 gauge blued steel.

Aluminium and galvanized steel pipe is not acceptable for use with the appliance. These

materials cannot withstand the extreme temperatures of a wood fire and can give off

toxic fumes when heated.

Do not use the connector pipe as a chimney.

Each chimney connector or stovepipe section must be installed to the stove flue collar

and to each other with the male (crimped) end toward the stove. See fig 5.

Fig. 5

This prevents any amount of condensed or liquid creosote from running down the

outside of the pipe or the stovetop. All joints, including the flue collar connection must

be secured with three sheet metal screws to ensure that the sections do not separate.

For the best performance the chimney connector should be as short and direct as

possible, with no more than two 90

elbows. The maximum horizontal run is 36" and a



recommended total length of stovepipe should not exceed 10 feet. Always slope

horizontal runs upward ¼" per foot toward the chimney.

No part of the chimney connector may pass through an attic or roof space, closet or

other concealed space, or through a floor ceiling. All sections of the chimney connectors

must be accessible for cleaning. Where passage through a wall or partition of

combustible construction is desired, the installation must conform with NFPA 211 or

CAN/CSA-B365, and is also addressed in this manual.

Page 6