- ページ 2

防犯カメラ Active Silicon HARRIER H.264のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Active Silicon HARRIER H.264 6 ページ。 Ip camera interface board

Evaluation Kit Contents

The Evaluation Kit for the Harrier IP (AS-CIB-IP-001-EVAL-A) contains all the parts needed to evaluate the

Harrier IP Camera Interface Board. Note that the evaluation kit does not include a Harrier IP Camera

Interface Board, FFC cable or camera, these need to be ordered separately.

Please check that you have all the parts listed below:

•

Multi-region 12V power supply (please fit the adapter suitable for your region)

•

Power adapter cable (barrel to 4-way JST connector)

•

Ethernet interface cable (JST connector to RJ45 socket)

Figure 4. Ethernet interface cable

Setting up the Boards

If you have purchased a pre-assembled camera you can skip this step.

1. Connect the Harrier IP Camera Interface Board (SoC board) (J2) to the Ethernet connection board

(J1) using a 24-way 0.5mm pitch double ended (same side contacts) FFC cable. Ensure that the

cable is connected the right way round. For the SoC board (J2) the metal contacts should face

towards the microSD socket. For the connection board (J1), the metal contacts should face the

PCB.

2. Connect the SoC board (J8) to the camera LVDS output using a KEL 30-way microcoax cable.

3. To avoid damage the boards must be securely mounted so that the cables are not strained.

Figure 6. Harrier Ethernet connection board

November 2021

HARRIER H.264 IP CAMERA INTERFACE BOARD

Figure 5. Power adapter cable

Figure 7. Harrier IP Camera Interface Board

(SoC board)

QUICK START GUIDE

Version 1.0 – November 2021

Page 2 of 6