- ページ 4

マルチメーター Dawson Tools DDM350のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dawson Tools DDM350 12 ページ。

ページを印刷する

1. Ncv (Non-Contact Voltage)

6.Avoid exposing batteries to humidity. Replace batteries

as soon as the low battery indicator appears.

7.Please keep the original packing for future shipping

purposes (ex. Calibration)

8.After opening the box, check for any damage during

delivery.

Safety Symbols

Important safety information, please

refer to the user's manual

Earth ground

Indicates compliance with requirements

for double insulation

Fuse must be replaced with ratings

specified in the manual.

Conforms to IEC1010-1 standards for

CATIII

overvoltage in category III installations

with a pollution degree of II.

Complies with European Union (EU)

standards

Complies with U.S. and Canadian safety

standards.

Important Safety Information

• Never use the meter to measure voltages that might

exceed 600V DC/AC above earth ground in category

III installations.

• Always be careful when working with voltage above

60V DC or 30VAC RMS. Keep fingers behind the probe

barriers while measuring.

• Inspect test leads and probes for cracks, breaks or

crazes on the insulation before using the meter.

• Repair or maintenance should be implemented by

trained personnel only.

Certification

CAT I :This meter has met IEC1010-1 standard with an

overvoltage category (CAT III) and pollution degree of 2.

The meter comp ies to EMC requirements.

Introduction

Overview

The DDM350 is a portable pen-type digital multimeter

featuring DC/AC voltage and current measurements,

resistance, capacitance, continuity, diode testing,

frequency and duty cycle, auto/manual range, worklight,

and an LCD w/backlight for easy reading. The slim and

lightweight design is mobile and ideal for both

professionals and hobbyists.

Figures and Components

Buttons and Components

1.Test Probe (+)

2.Probe Cap

3.NCV Indicator

4.Protective Ring

5.LCD Display

6.Rotary Switch

7.FUNC (Function) Button

8.RAN (Range) Button

(Work light) Button

10.NCV (Non-Contact Voltage) Button

11.H/

(Hold/Backlight) Button

12.Hz/% (Frequency/Duty Cycle) Button

13.COM Jack (-)