ページを印刷する
1
Leave an air gap of at leas t
/
˝ (5 mm) between the
4
appliance and the front of other cabinets.
Secure the appliance with the screws provided.
Do not seal the ventilation openings of the
appliance with additional s trips.
Do not ins tall the model that feat ures the controls
at the bottom above a dishwasher. Steam from the
dishwasher might damage the electronics of the
s team oven.
Combination with Oven BO 2.. –
Figure 6a /6b
The rear of the series BO 2.. ovens has tapered
edges. Guide the connecting cable, the water inlet
hose and the drainage hose on the rear left side of
the cabinet down to the connections.
If the hoses cannot be guided down on the rear left
side of the cabinet when the appliance is fitted
above an oven, move the cabinet at leas t 1
3
/
˝
8
(35 mm) from the wall and fit a side wall.
Fit the s team oven fir s t, then the oven.
When ins talling the appliances side-by-side, the
door handles mus t be in the centre.
Combination with Warming Drawer
WS 2..
Fit the warming drawer fir s t. Follow the ins tallation
ins tructions for the warming drawer.
Guide the water inlet hose and the drainage hose of
the s team oven on the rear of the cabinet down to
the connections. Slide the s team oven into the
cabinet, on top of the warming drawer.
Important: When ins talling the oven take care not
to scratch the panel or the handle of the warming
drawer.
Removal
Disconnect the appliance from the power supply.
Loosen the securing screws.
Lift the appliance slightly and pull it out completely.
7