- ページ 9

メディア・コンバーター Active Silicon FireBirdのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Active Silicon FireBird 12 ページ。 Frame grabbers
Active Silicon FireBird にも：クイック・スタート・マニュアル (12 ページ)

ページを印刷する

GENTL CAMERA LINK SETUP UTILITY

The GenTL CL Setup Utility needs to

be run to allow the use of Camera Link

cameras that support GenICam. It

is needed because Camera Link pre-

dates GenICam so cameras cannot be

discovered automatically.

The utility only needs to be run once

for a given camera connection. To

Use Camera Probing to select a channel on

a FireBird board, and the camera that is

connected to it.

The list of cameras will show all the CLProtocol

DLLs installed on the machine, including the

generic GenICam#GenCP_01_00 DLL which

should be used for all GenCP cameras.

Click Add to attempt to connect to the camera.

If it is found it will be added to the list of

known cameras.

The Status Log shows what the

utility has done.

FireBird Frame Grabbers – Quickstart Guide v2.4

do this run it from the Tools menu in

ActiveCapture, after ensuring that no

cameras are open in ActiveCapture, and

closing any other application that may

have the cameras open.

After it has been run, refresh the Device

List in the GenTL consumer application

in use, such as ActiveCapure, and the

camera should then be listed and

operate correctly.

The utility associates a CLProtocol DLL

with a specific Camera Link port on

FireBird. For cameras using GenCP, a

generic GenCP DLL is provided as part of

the FireBird installation.

For other cameras, note that only

Camera Link cameras that are provided

with a CLProtocol DLL can be used with

GenICam. Older Camera Link cameras

may not provide a suitable DLL and

therefore will not work with GenICam

applications. Contact the camera vendor

to obtain the correct DLL file.

This list shows all the cameras that have been

found and added using the Camera Probing

controls.

Click Save when the cameras have been

correctly added.

A GenTL application will attempt to connect

to these cameras, so if a camera is removed

from a system or moved to another port,

select the camera and click Delete.