- ページ 4
ジャックス Hi-Force ALUMINIUM HP232のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Hi-Force ALUMINIUM HP232 15 ページ。 Hp-manually operated hydraulic pump
Hi-Force ALUMINIUM HP232 にも： 取扱説明書 (6 ページ)
ページを印刷する
NEVER handle a pressurised hydraulic hose. Hydraulic fluid escaping under pressure from a
ruptured hose can penetrate the skin and lead to a significant medical emergency, and in some
cases, death. Should this incident occur, seek out medical attention immediately.
Seek medical attention immediately if a hydraulic injection injury (no matter how minor) occurs.
The system operating pressure MUST NOT exceed the pressure rating of the lowest-rated
component in the system. It is good practice to use a pressure gauge to monitor the entire system.
NEVER attempt to pressurise a system that is not correctly coupled to its operational pump.
NEVER attempt to disconnect a hose from a hydraulic system until the system's pressure has been
completely released. Doing so can result in that pressure becoming trapped within the system and
relieving trapped pressure can be dangerous.
NEVER try to relieve trapped hydraulic pressure in the system by loosening or attempting to remove
the coupler. Trapped hydraulic pressure can cause a loosened coupler to dislodge unexpectedly
with great force. This action could result in serious personal injury or death.
Loosening a coupler under pressure can result in the escape of hydraulic fluid at high pressure,
which can penetrate the skin and cause significant injury or death.
NEVER use a hammer and punch to unseat a coupler check valve that is under pressure. Doing so
could result in the sudden, uncontrolled release of hydraulic fluid at high pressure, which could cause
significant injury or death.
NEVER attempt to solve, or clean-up leaks in the system while the system is pressurised.
Immediately replace any worn or damaged parts using genuine Hi-Force parts only.
Do not use any hydraulic equipment if you are under the influence of alcohol, drugs or medication.
Lack of attention whilst operating high-pressure hydraulic tools can result in personal injury or death.
NEVER lift, carry or move any hydraulic components by the hose or hoses connected to them.
Avoid damaging hydraulic hoses. ALWAYS route hoses to ensure that they are free from sharp
bends and kinks. Using a sharply bent or kinked hose will result in severe back-pressure, which can
lead to hose failure.
NEVER use a coupler/s to lift, carry or position a tool.
NEVER pressurise an unconnected male coupler/s.
Failure to observe and obey the following safety precautions could result
in property damage, equipment damage or minor / moderate personal
injury;
Operating Instruction Manual:
OM-HP-ALUMINIUM-01
4
Serial Numbers:
From: DF2001