- ページ 8

ジャックス Hi-Force HP227のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Hi-Force HP227 13 ページ。 Manually operated hydraulic pump - steel
Hi-Force HP227 にも：取扱説明書 (6 ページ)

6.1 Before First Use / Preparation



Check for any signs of wear in the pump or connected components.



Unscrew the transit plug (3) and fit the breather (4) this will maximise the oil volume available and

prevent oil reservoir pressure build up.

6.2 Filling the Pump with Fluid - ISO15 grade.

IMPORTANT:

Only add fluid to the reservoir when the connected system is fully de-pressurised and

returned to its closed position. Failure to do so will result in the system containing more fluid

than the reservoir can hold.

Fill / top-up the pump as follows: HP110



Stand the pump Head down on a firm, level surface.



Remove the filler cap (5) from the reservoir.



Fill the reservoir with clean, high quality ISO15 hydraulic oil, leaving a small air space of

approximately 1-2cm between the top of the fluid and the filler plug.



Replace the filler cap (5).

Fill / top-up the pump as follows: HP227/HP257



Stand the pump on a firm, level surface.



Remove the transit plug/breather (3/4) from the reservoir.



Fill the reservoir with clean, high quality ISO15 hydraulic oil, leaving a small air space of

approximately 1-2cm between the top of the fluid and the filler plug.



Replace the transit plug/breather (3/4).

6.3 Hydraulic Connections

Remove the hexagon headed plug and make a hydraulic connection to the outlet port (6). This port has a

3/8" NPT female thread, and the connection should be sealed, as appropriate, with a suitable thread sealant.

DO NOT overtighten this fitting. It can cause damage to the pump head or lead to failure

of the fitting at below rated pressure.

When making a connection between two couplers, ensure that these connections are fully connected, with

no thread gap and hand tight only.

Operating Instruction Manual:

OM-HP-STEEL-01

6.0 Installation / Setup

Serial Numbers:

From: DF6685