- ページ 2

エクステンダー Daxten VOYAGER SERIALのPDF パンフレットをオンラインで閲覧またはダウンロードできます。Daxten VOYAGER SERIAL 2 ページ。

Voyager serial

Baud Rate Selection

The daughterboard in the Remote unit has a jumper which is used to select between baud

rates of 9600 (default) and 19200. Refer to the drawing below for the location of this

jumper. Ensure the Rmote Unit is powered down before changing the jumper setting.

Hardware Flow Control

Most applications for the serial link will not require hardware flow control and therefore

However, the daughterboards in both the Local and Remote Units have a series of

jumpers which allow the selection of two alternative hardware flow control schemes

across the CAT5 link, or local loopback of the flow control lines for those PC's and

peripherals that require the presence of a handshaking control signal to enable them.

Do not alter the position of any jumpers or headers on the daughterboard except for

those described above and whose locations are shown below.

Use with a Serial Mouse

As standard the serial link does not support a serial mouse. If you have a PC which does

not have a PS/2 mouse port you should plug a PS/2 mouse into the Remote Unit and use

it is not enabled by default.

a 2146-00C PS/2-Serial Mouse converter at the CPU side. If however, you have a special

serial mouse device such as an industrial trackball which is not available with a PS/2

interface it may be possible to use it through the extender if a custom firmware revision is

supplied. Please contact technical support for details.

Dual Unit (Model 1035-21R) Specific Notes

Please note that the remote serial link is always active even if the Local console is

selected.

Daxten Ltd

4 Harp Business Centre

Apsley Way

London NW2 7LW

Serial

Daughter

Board

Tel.: +44 (0)20 8438 3800

Fax: +44 (0)20 8438 3899