- ページ 10
クックトップ Gaggenau VG 295 234 AUのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gaggenau VG 295 234 AU 12 ページ。
ページを印刷する
Discoloured burner parts
After prolonged operation, the burners (burner lid,
burner ring and burner head) will become darker
through natural oxidation. You can remove this
discoloration as follows:
1
Mix equal parts of white vinegar with a max. 8 %
acid (household vinegar) and warm water.
2
Soak the discolored burner parts for no longer
than 10 minutes in the solution. Remove stubborn
stains with a cloth or sponge.
3
Rinse the burner parts thoroughly in clear water
and dry completely before use.
Caution! The surface will be damaged if the solution
is too concentrated or the burner parts are left in
vinegar for too long!
Trouble shooting
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
Fault
Burner does not ignite when
switched on, operation indica-
tors are off.
Burner does not ignite when
switched on, operation indicator
of the switched on burner is flash-
ing.
Burner goes off during operation,
operation indicators go off, only
the operation indicator of the
affected burner continues to
flash for a few seconds.
Burners go off during operation,
operation indicators go off.
Burners go off during operation,
all operation indicators are flash-
ing.
The kitchen smells of gas.
10
Possible cause
No electrical power.
Malfunction of the burner or the gas
supply.
Malfunction of the burner or the gas
supply.
Power cut
Overheating protection
There may be a leak in the gas cylin-
der coupling.
Do not use these cleaners
▯
Scouring or chemically aggressive cleaners
▯
Don't allow acidic cleaners (e.g. vinegar, citric
acid, etc.) to get on the frame or panel.
▯
Cleaners containing chlorine or with a high
content of alcohol
▯
Oven cleaner
▯
Hard and scratchy sponges, brushes or scouring
pads
▯
Thoroughly wash out new sponge cloths before
using them.
Solution
Turn control knob to 0. Check the fuse box if the
fuse has tripped.
Turn control knob to 0.
Check:
▯
Are all burner parts correctly assembled?
▯
Is the gas shut-off valve open?
▯
Is the burner dry and clean?
▯
Is there an air pocket in the gas supply line after
first installation or changing the LP (propane)
gas tank?
▯
LP (propane) gas: is the gas tank empty?
Turn all control knobs to 0. Wait, until the appliance
has cooled!
Check affected burner:
▯
Are all burner parts correctly assembled?
▯
Is the electrode soiled (food remains) or wet?
▯
Is the burner soiled by boiled over food?
▯
Check for strong draughts (for example open
window behind the cooktop)?
▯
LP (propane) gas: is the gas tank empty?
Turn all control knobs to 0. Check the power supply.
There will be no automatic re-ignition after a power
cut.
Turn all control knobs to 0. Wait, until operation indi-
cators go off.
Check that the coupling is sound.