- ページ 8
クックトップ Gaggenau VG 425 210 CNのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gaggenau VG 425 210 CN 16 ページ。
ページを印刷する
Operation
The markings on the control knob show the setting
from level 1 to 12 and simmering Â.
Notes
‒
Only light a burner if the pan support and burner
parts are properly assembled.
‒
Make sure the burners and electrodes are clean
and dry.
‒
Only use the recommended accessories. Do not
cover the stainless steel cooktop base (e.g. with
aluminium foil).
‒
Do not cover the air inlet underneath the pan
support.
Caution! Heat damage to the extractor hood: Always
switch on the extractor hood while the gas cooktop is
in use. When using several cooking positions select a
higher fan level on the extractor hood. Make sure there
is a sufficient ventilation of the room.
Switching on
Your cooktop features automatic fast ignition.
1
Place a suitable pot or pan on the corresponding
cooking position.
2
Press down the corresponding control knob and
turn it anticlockwise to the required cooking level.
The burner lights automatically.
The cooking level can be set by slowly turning the
control knob.
Notes
‒
When using large pots or pans you should ignite
the burner on a low cooking level.
‒
When being switched on, a short sound may be
heard when the electronics of the gas hob opens
the gas supply valve. This is a normal condition.
‒
Every time the gas hob is switched on, the
electronics runs an auto test. The electrode fires
and the burner ignites after a few seconds.
‒
The cooktop cannot be used during a power
failure.
8
Simmering
The burner switches the flame on and off when
simmering. You can use simmering for example to melt
chocolate or prepare delicate sauces.
Turn the control knob to Â. The time slot for switching
on / switching off is approx. 30 seconds.
Electronic flame detection and
automatic re-ignition
For your safety the cooktop features electronic flame
monitoring. Should the flame go out during operation
(e.g. because of a draught), the appliance will
automatically re-ignite the burner.
Should the re-ignition be unsuccessful (e.g. burner is
soiled by spilled over food or liquid), the gas supply is
switched off. The luminous disc behind the control
knob flashes.
Turn the control knob to the OFF position. After the
appliance has cooled down sufficiently, check this
burner to see if all the burner parts have been
assembled correctly. Check if the burner or the
electrode has been soiled (see trouble shooting
guide).
Switching off
Fully turn the control knob to the OFF position. The
electronics of the appliance switches the gas supply
off.
ã
Risk of burns!
When the appliance cover is closed, heat will
accumulate. Only close the appliance cover when the
appliance has cooled down. Never switch the
appliance on with the appliance cover closed. Do not
rest food on the appliance cover or use it to keep food
warm.
Residual heat indicator
The luminous disc behind the control knob flashes
after switching off, to indicate that the appliance has
still not cooled down to such an extent that it can be
touched safely.