- ページ 7

クックトップ Gaggenau VI 230 620のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Gaggenau VI 230 620 10 ページ。

ページを印刷する

Prepare Installation Space

P r e p a r e I n s t a l l a t i o n S p a c e

C reate the cut-out in the countertop according to the

installation diagram. The angle of the cut surface to the

countertop must be 90°.

The lateral cut-out edges must be flat in order to ensure

that the retaining springs are positioned properly on the

appliance. With multi-layered countertops, secure strips

laterally in the cut-out if necessary.

After creating cut-out, remove shavings. Seal cut

surfaces in a heat- and water-resistant manner.

Observe minimum distance between device underside

and cabinet surfaces of

The worktop into which the cooktop is installed must be

heat-resistant up to 140° F (90 °C).

The worktop must be reinforced if it is less than

(20 mm) thick.

If the thickness of the worktop into which the cooktop is

installed does not comply with the specifications,

reinforce the worktop using a fire- and water-resistant

material until it reaches the minimum thickness.

Otherwise, sufficient stability cannot be assured.

The worktop into which the cooktop is installed should

▯

withstand loads of approx. 133 lbs (60 kg).

Confirm the cooktop is level only after it has been

▯

installed.

Cutting out countertop

" (10 mm).

Combining several Vario appliances: Consider additional

space requirement for the connecting strip VV 200 when

making the cut-out. Appliances can also be installed in

individual cut-outs, if a minimum clearance of 1½"

(40 mm) between the appliances is observed.

Installation accessories

VD 200 020

VV 200 010

VV 200 020

Use the accessories only as indicated. The manufacturer

assumes no liability for incorrect usage of the

accessories.

Ventilation

inch

To guarantee that the appliance works correctly, the

cooktop MUST be sufficiently ventilated.

Since the ventilation in the lower section of the appliance

requires a sufficient supply of fresh air, the cabinet must

be designed accordingly. The following is required for

this:

A minimum clearance between the rear of the

▯

cupboard and the kitchen wall, and between the

surface of the worktop and the upper area of the

drawer.

Prepare Installation Space

Black appliance cover

Stainless steel connection strip for

combining with other Vario 200

appliances

Black connection strip for combining

with other Vario 200 appliances

en-us