- ページ 6
DJ機材 Great Lighting 5R 200WのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Great Lighting 5R 200W 15 ページ。
ページを印刷するEncoder Pan-Tilt
No DMX signal
Display Power Save
Burn On Startup
Load Default Back
Back
3.3. "Information" Interface
Options
Software version
Total Fixture Hours
Partial Fixture Hours
Total Lamp Hours
Partial Lamp Hours
DMX Monitor
System Errors
Back
3.4. "Manual" Interface
This interface is used to control the current light, neither belong to slave status (do not receive DMX signal), nor
belong to the host state (do not send DMX signal)
Options
Reset
Color Wheel
0-255
0-255
。 。 。 。 。 。
Gobo Time
0-255
Lamp
On
Control
Off
on
Exchanging XY channels（Pan/Tilt fine included）
on
Use Encoder (optocoupler) to judge if the light is out of step or not, and
rectify the position automatically.
off
Don't use Encorder (optocoupler) to rectify the position
stay
Stay the previous status and keep running
reset
Motor return and stop running
on
Screen light is off automatically after 30secs
off
Screen light keep on
off
Reset directly when power on， lamp stay off （ operate the menu or console
to light up the lamp)
on
Lamp on when power on，and reset after the lamp is fully lighted up.
Press "Confirm" button to see the confirming dialog, and press "Confirm"
button again to recover default setting.
Return
The current software version
Total time of using the light (accurate to the minute)
Current time used (accurate to the minute)
Total time of lamp using (accurate to the minute)
Current time of lamp used (accurate to the minute)
Click here to go to the sub-interface, the channel value is shown by value and
percentage
If the red ERR indicator is on, indicates the lamp is running with error, Click here to go
to the sub-interface
pressing "OK" key.
Note: Sometimes the error may be not by Hall or optocoupler, but the motor cable is
connected invercely.
Return
Press the OK button and you will see a confirmation dialog , click "OK" key to enter
the reset interface, all motor reset again.
Press "Confirm" button to edit. First is for
"Down" to change the address codes. Press "Confirm" button the second time to edit
"ten's digit", and press again the
press it again to exit editing.
Illustrate
and check the error details. Error records can be delete by
Instructions
"Confirm" button to edit
- 6 -
"hundred's digit", and press
"unit's digit".
"Up" and
Please