- ページ 14

セキュリティシステム 2gig Technologies Go!Control PanelのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。2gig Technologies Go!Control Panel 20 ページ。

ページを印刷する

Go!Control Wireless Security System | User Guide

Quick Exit in Stay Mode

A programmable option, called Quick Exit

may be displayed on the Security screen

while the system is armed in Stay mode. Tap

the Quick Exit button to start a timer to

allow someone to exit or enter through a

sensor‐protected door programmed for

delay without having to disarm the entire

system. When the delay timer runs out, the

system returns to the normal Stay mode.

The Quick Exit option can be turned on or off

by your installer, see "Installer Programmed

Options" on page 41 to understand the

options that have been programmed for

your system.

SILENT CONTROL IN STAY

MODE

Three options for silencing the beeps and

announcements are available when arming

or disarming the system in Stay Mode.

•

At the Home or Security screen, tap the

Silent Control button.

•

At the Ready to Arm screen, select the

Silent Exit check box.

•

On the Exit Delay screen, tap Silence.

Selecting any of these options silences the

Control Panel beeps and announcements,

and when arming, selecting the option

doubles the length of the Exit Delay.

Arming to Stay Mode

Use Stay Mode to arm the system when

anyone is at home. Stay Mode normally has

an Entry Delay so a user with a user code can

re‐enter without causing an alarm.

Close all protected perimeter doors and

windows before arming.

Verify that the

Panel is lit GREEN indicating that the

button on the Control

system is ready to arm. The Security and

Arm buttons on the display is GREEN

when all sensors are closed.

NOTE: If you want to arm the system

quietly without sounding any

announcements, tap

performing these steps:

•

At Ready to Arm screen, place a

checkmark in the Silent Exit box.

•

During exit delay tap Silence.

At the Security or Menu screen, tap

Arm.

NOTE: If there are any open perimeter

door or window sensors, the

Bypass screen appears. Close all

the sensors displayed or tap

Bypass All to force bypass the

displayed sensors.

NOTE: Bypassed sensors do not trigger

an alarm. (To bypass sensors, enter

a user code unless the installer has

set the system for Quick Bypass).

On the Ready to Arm screen, select the

Entry Delay check box when arming the

system in Stay mode.

If no one is expected to re‐enter, the

system can be armed without an Entry

Delay. All perimeter doors will trigger the

alarm instantly. To arm with all exit/

entry perimeter doors as instant, remove

the checkmark from the Entry Delay box.

Tap Stay to arm the system.

NOTE: To arm the system, you may

need to enter a user code if your

installer has turned off the

system's Quick Arming feature.

The system will arm and shows the Exit

Delay counting down. When the Exit

Delay expires, the system is fully armed

in the Stay mode.

before