- ページ 8

ジャックス HI-PRESS TANGYE HYDRALITE PS1230のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。HI-PRESS TANGYE HYDRALITE PS1230 10 ページ。

HYDRACLAW

Description

The jack is constructed from high strength ferrous materials throughout. The forged claw is

guided in the body to relieve the ram of bending loads.

Oil Level Check

The jacks are supplied filled and ready for use. However, before using the

the oil level should be checked. The oil used should be high quality hydraulic oil such as Shell

Tellus ISO32 or equivalent.

To check the oil level, stand the jack on its base in an upright position, remove the filler plug and

seal (1) and check that the oil is level with the bottom of the filler plug hole.

When refilling from empty, or if air is in the circuit, the following procedure should be observed:

Ensure that the release valve (2) located inside the operating socket (3) is open. With

the jack standing on its base, fill with oil to the bottom of the filler plug hole, replace the

filler plug and seal and close the release valve screw.

Pump the ram/claw to its full extent and turn the jack upside down. Whilst in the

inverted position, open the release valve and apply pressure on the jack body to press

the ram/claw to its bottom position.

Repeat this procedure as often as necessary to remove all

stand the jack on its base, remove the filler plug and check the oil is level with the

bottom of the filler plughole. If not, top up to this level, replace filler plug and seal.

jack for the first time,

air from the system. Again