- ページ 11
換気フード Gaggenau AW 250のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gaggenau AW 250 16 ページ。 Wall ventilation hood
ページを印刷する
2
1
Cleaning and care
Cleaning the grease filters
The grease filter saturation display F flashes after
an operating time of 30 hours to you indicate to you
that you should clean the grease filter. The grease
filters can of course be cleaned at any time, even if
the grease filter saturation display has not started
to flash.
The stainless steel grease filters can be
removed easily for cleaning:
1
Disconnect the power supply (switch off the
fuse).
2
Take hold of the edge extraction segments at the
side, pull them downand remove.
3
Depress the handles on the grease filtersand fold
down the grease filters.
3
4
Clean the grease filters.
5
Re-install the cleaned grease filters.
6
Attach the edge extraction segments inreverse
sequence.
7
You can clean the stainless steel grease filters
in a dishwasher at a maximum temperature of
65°C, where it should be supported vertically
to allow food or rinsing residues to drain off.
If possible, the inner parts of the housing should be
wiped out in hot rinsing water when replacing the
filters.
Caution:
when cleaning the inside of the housing, beware of
protruding parts..
After having cleaned them, re-insert the grease
filters in the wall extractor in reverse order.
Important:
the handles of both grease filters must be visible
after assembly.
Press the F key to set the elapsed hours counter to
zero. Flashing of the indicating lamp goes off.
Cleaning the extractor hood
Clean the exterior of your extractor hood with a soft
cloth and mild detergent solution. Do not use any
strong, caustic or abrasive cleaning agents. Do not
use any abrasive sponges or brushes either.
11