- ページ 4

電動工具 Hi-Spec DT40235のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Hi-Spec DT40235 7 ページ。 0-15-30w soldering iron set

drilling, and other construction activities, contain harmful chemicals. Reduce your risk

of exposure to these chemicals: work in a well ventilated area, and work with

approved safety equipment, such as those dust masks that are specially designed to

filter out microscopic particles.

4) General Power Tool Use and Care

a. Do not force the power tool. Use the correct power tool for your application. The

correct power tool will do the job better and safer at the rate for which it was designed.

b. Do not use the power tool if the switch does not turn it on and off. Any power tool that

cannot be controlled with the switch is dangerous and must be repaired.

c. Disconnect the plug from the power source and/or the battery pack from the power

tool before making any adjustments, changing accessories, or storing power tools.

Such preventive safety measures reduce the risk of starting the power tool

accidentally.

d. Store idle power tools out of the reach of children and do not allow persons unfamiliar

with the power tool or these instructions to operate the power tool. Power tools are

dangerous in the hands of untrained users.

e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of

parts and any other condition that may affect the power tool's operation. If damaged,

have the power tool repaired before use. Many accidents are caused by poorly

maintained power tools.

f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp

cutting edges are less likely to bind and are easier to control.

g. Use the power tool, accessories and tool bits etc. in accordance with these

instructions, taking into account the working conditions and the work to be performed

in a hazardous situation.

h. Have your power tool serviced by a qualified repair person using only identical

replacement parts. This will ensure that the safety of the power tool is maintained.

5) Specific Power Tool Safety Warnings, Use and Care.

ADDITIONAL OPERATIONAL SAFETY INSTRUCTIONS FOR THE SOLDER IRON

a. Make certain that the rated power stated on the appliance rated plate agrees with the

local mains voltage before connecting the appliance to the mains.

b. Be sure to disconnect the machine from the mains after finishing work

c. Allow the device to cool down completely before storage! Rest the device on the

stand provided or on a non-flammable surface during breaks or after finishing work.

Do not leave the machine unsupervised until it has cooled down completely.

d. Do not use the device if the handle, mains cable or plug show signs of damage. Send

the device to an authorized workshop for repair. Never open the device yourself.

e. Keep the device away from children!

f. Do not expose the device to water or moisture.

Owner's Manual

Page 3 of 6