セキュリティシステム 2gig Technologies VarioのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。2gig Technologies Vario 6 ページ。 Voice module
2gig Technologies Vario にも： クイック・インストール・マニュアル (18 ページ), クイック・ユーザー・マニュアル (10 ページ)
ページを印刷する
2GIG® Vario System
2GIG Vario Voice Module
10012671 A
Installation Instructions
The 2GIG Vario Voice Module provides audible information about the status of the 2GIG Vario System, and enables any remote, touch-tone (DTFM) telephone to
act as a keypad for the system. When a system event occurs (such as an alarm activation) the Voice Module notifies a system user by calling a specified telephone
and playing a pre-recorded announcement.
NOTE:
For instructions on how to program the Voice Module, see the 2GIG Vario System Installation Guide.
Installing the Voice Module
VOICE MODULE
POWER
LED1
RED
BLK
YEL GRN
AUX
COM
BUS
SW
Description
1
Omit Tamper
2
OPT
3
Test
4
Intern MIC
Nortek Security & Control | 1950 Camino Vida Roble, Suite 150 | Carlsbad, CA 92008-6517 | USA | 800-421-1587 | www.nortekcontrol.com
Rec
Play
DIP SW1
1
2
3
4
AUX
COM LED
TMP
Voice
(to panel)
DIP Switches
Instead of a short with the TMP/COM terminal block
N/A
Connected in parallel to all output channels. It enables the user
to listed to all played messages using a speaker (at least 32
Ohm) connected between the Test Spkr and COM terminals.
Select an external or internal microphone for recording
messages:
On: Enables recording messages from the microphone located
on the Voice Module board.
Off: Enables recording messages from a microphone located
on the 2GIG Vario Listen-in & Speak Module.
Copyright © 2016 Nortek Security & Control LLC.
MIC1
Out
In1
In2
In3
Message Box
Usage
1