- ページ 2

農機具 GREAT PLAINS 605NTのPDF メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。GREAT PLAINS 605NT 7 ページ。 Six foot no-till

When transporting the drill, transport locks should always be used. This will prevent

damage to the drill and possible personal injury should hydraulic failure occur.

A) To install transport locks place the channel over the cylinder rods and install pin

with retainer clip. Both cylinders need the channel locks installed.

B) Always disengage the lockout hub before transporting the drill.

Engaged

ADJUSTMENT BEFORE GOING TO THE FIELD

1) Hitching the drill to the tractor.

A) When hitching the 3P605NT to the tractor, make sure that the tractor has the

right amount of front weight. Remove the tractor draw bar or damage will occur

to the drive wheel of the drill. Lower the tractor's three-point arms and back up

to the drill. Pin the upper arm to the center link of the drill. Pin the lower arms to

the drill, raise the drill and watch for any interference at the tractor. If the front of

tractor is light, add additional front weights.

B) Hitching the 605NT to the tractor. With the drill lowered and tongue jack in the

parking position, level the tongue, then back the tractor to the drill hitch, match

the tractor drawbar height to the drill tongue by moving the hitch height

adjustment as needed.

TRANSPORTING

Lock-Out Hub

Disengaged

Lock Pin, Transport Position