農機具 GREAT PLAINS 606NTのPDF メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。GREAT PLAINS 606NT 7 ページ。 Six foot no-till drills
GREAT PLAINS 606NT にも：取付説明書 (6 ページ)

SIX

FOOT

NO-

TILL

605NT / 606NT

3P605NT / 3P606NT

Proper servicing and adjustment is the key to the long life of any farm implement.

With careful and systematic inspection of your grain drill, you can avoid costly

downtime and repair.

1) After using your drill for several hours, check all bolts to be sure they are tight.

Refer to the torque value chart in your operator's manual.

2) A) Lubricate the seed cup drive sprocket shaft by coating with Never Seeze.

B) Lubricate all chains with chain lube.

C) Grease the clutch cam fittings. With the clutch jaws in the open position,

lubricate with slip plate or a chain lube between the jaws.

D) Grease the coulter arm pivots every 6 to 8 hours.

E) Grease the wheel arm pivot castings every 6 to 8 hours.

F) Grease coulter hub bearings and end wheel hub bearing before start of

each planting season.

3) Disk scrapers should be properly adjusted.

4) Check for the proper air pressure in the implement tires.

The 605NT 9.5L x 15"is 44 psi.

The 3P605NT 5.70 drive wheel tire is 50 psi.

5) Check all chain idlers for proper adjustment. To adjust the chain in the drive axle

tube, loosen jam nut on top of axle tube and screw adjusting stud in to tighten the chain

and retighten jam nut.

NOTE: DO NOT OVER TIGHTEN CHAINS.

01-12

DRILL MAINTENANCE

(1/4" deflection per foot between shaft centers vertical drive)

(1/2" deflection per foot between shaft centers horizontal drive)

(All drives with more than 3 feet between shaft centers should be

Adjusted to 1/4" deflection per foot between shaft centers