- ページ 15
ソウ Hi-Tech Diamond 31-006のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Hi-Tech Diamond 31-006 16 ページ。 10" slab saw
ページを印刷するTROUBLESHOOTING
Why is there excessive oil or water
spraying from the saw blade?
If there is excessive oil or water spraying from
the saw blade while you're cutting, this means
you have over-filled the water reservoir. Fill
the reservoir with water (or oil) so that just the
bottom of the saw blade is sitting in it, about 1/8"
deep (see below).
My saw blades keep rusting. How
can I prevent this?
Rusting occurs when the saw blade is not
properly dried off after each use or if the saw
blade is left sitting in the saw machine's water
reservoir when not in use. The best solution to
prevent rusting is to remove the saw blade from
your trim saw after each use and dry with a paper
towel or cloth. Remember to always keep saw
blades away from children.
What happens if my saw machine
overheats?
The housing that the slab saw is made out of is
polyethylene, which can deform if the machine
is run too long, causing the machine to overheat.
To prevent this from happening, you must take time
to cool your machine. We suggest running your
slab saw for 30 minutes on, 30 minutes off to cool.
Alternatively, you can use an external fan to blow air
through the vent located on the side of the motor
housing. This will help prolong usage time.
I can't remove the arbor from the
motor shaft.
If you can't remove the arbor from the motor
shaft using the Allen wrench, it is most likely
because the arbor and motor shaft seized
together. This is a result from not oiling the inside
of the arbor according to the oiling instructions
on page 10. If it impossible to remove, please
contact Hi-Tech Diamond at 1 (630) 596-9909 and
one of our specialized technicians will help you
over the phone for correct removal.
Do you sell electrical spare
parts for my slab saw? Whom
do I contact if I need a repair or
replacement for my slab saw?
Due to the technical nature of our machines,
we do not offer electrical spare parts for you to
install yourself such as motors, speed controllers,
rectifiers, etc. Instead, we offer a repair
service that is done in-house by our qualified
technicians. For more information about our
repair service, visit hitechdiamond.com/repairs.
15