- ページ 9

ロボット工学 DynAccess Hydra MonoskiのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DynAccess Hydra Monoski 16 ページ。

To change the center of gravity:

1. Lay the monoski on its side.

2. Locate the two bolts connecting the foot tower to the foot.

3. Remove the two bolts, and put them and the six washer in a safe place. You may need

to loosen the bolts just above the removed bolts to release the pressure.

4. Slide the frame forward or backward to adjust your center of gravity and center it with

the proper holes. Align the holes perfectly, using for example a drift (tapered alignment)

pin.

5. Replace the bolts, washers and nuts

6. Take care to ensure that all screws are tightened properly. Do not over-torque the bolts.

Caution!

Make sure to install all parts, in particular the washers, correctly. The thick conical washers are

very important; do not replace them with flat washers as this may damage the rodends and

lead to failure.

Sitting in the Seat:

When sitting in the bucket seat, sit deeply so that it is snug throughout your entire hips and

bottom. You may want to lean forward and wiggle down into the seat, adjusting so that your

pelvis is as far into the rear of the seat as possible.

Once you are seated properly adjust the height of the footrest. You may want your thighs to

contact the seat edge slightly, but not so hard that you could not slide a finger under your

thighs.