- ページ 7
アンプ DYNACO Dynakit ST35のPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。DYNACO Dynakit ST35 17 ページ。
ページを印刷する
:~
5-LUG TERMINAL STRIP
15( ) Cut the black, orange and yellow leads of the LEFT
output transformer to 3
1
12"
long. Twist all three of
these leads together, and connect the black lead to
lug C of the LEFT 3-screw terminal strip.
16(
Connect the orange lead to lug 8 of the LEFT
3-screw terminal strip (S).
17 (
Connect the yellow lead to lug 16 of the LEFT
3-screw terminal strip.
IS!
The RIGHT output transformer leads are connected
next. First, cut the blue-and-white and green-and-
white leads to exactly 2" long. Strip and tin the ends.
and twist the leads together. C0nnect the blue-and-
white lead to pin #7 of V-S on the RIGHT circuit
board! S).
19(
Connect the green-and-white lead to pin #9 of V-S
(S) .
20 ()
Twist together the blue and green leads from the
RIGHT 3-SCREW TERMINAL STRIP
Pictorial Diagram #2: Wiring of transformer leads.
RIGHT output transformer. Connect the blue lead
to pin #7 of V-6 on the RIGHT circuit board
(S).
21 ( ) Connect the green lead to pin #9 of V-6. Be sure
that exposed wire ends or stray filaments from them
cannot touch other wires or terminals, or cause a
short-circuit to -the chassis or hardware.
22 (
Cut the red lead from the RIGHT output trans-
former to
4V2"
long, and connect it to lug
#2
of the
niter capacitor (square symbol).
23 ( ) Cut th€ black, orange and yellow leads of the RIGHT
output transformer to 3
1 / / '
long. Twist these three
leads together, and connect the black lead to lug
C of the RIGHT 3-screw terminal strip.
24(
Connect the orange lead to lug 8 of the RIGHT
3-screw terminal strip (S).
25 (
Connect the yellow lead to lug 16 of the RIGHT
3-screw tel'minal strip.
7