- ページ 6
ドローン＆クアッドコプターアクセサリー 7SenseTech Hawk 4KのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。7SenseTech Hawk 4K 10 ページ。
ページを印刷するAssembly
Instruction of RC Watch
①Power on/off(press&hold)
Front LEDs off(press once)
②Taking Off（press once）
Left Rotate（press&hold）
Drone GPS Signals
Stabilize
③USB charge port
⑩ Fly Leftwards(press&hold)
Follow Tracker GPS Singals
④ Auto land（press once）
Return-home（press&hold）
⑤ Gimbal tilt Up（Left rotate）
Gimbal tilt Down (Right rotate)
Notes: Do not press two buttons at the same time which will interfere each other.
Press the hover button first before switching one flight mode to another.
One Key to Take off
Before take-off, press and hold the unlock button to check if the four
motors are rotating properly.
Press the take-off button once in the unlocking status and the drone
will ascend to 5 meters and hover in place.
Take off
Unlock
Unlock (press&hold)
Take off (press once)
Notes: The motors will be locked again if the aircraft doesn't take off within 6 seconds after unlock.
After taking off, the drone will hover in place if no further command is given from the watch.
⑨ Ascend(press once)
Fly forward(press&hold)
⑧ Follow-me（press once）
Right Rotate（press&hold）
Drone Battery Level
Flight Height
⑦Hover（press once）
Unlock（press&hold）
⑿ Fly Rightwards(press&hold)
Watch Battery Level
⑥Rotate in place（press once）
Orbit fly（press&hold）
⑾ Descend（press once）
Fly Backward(press&hold)
Land
Land (press once)
Basic Fly Control
Press and hold the four arrow buttons and the drone will keep
flying in forward, backward, leftward or rightward directions as
long as you hold one of the buttons.
If you press the forward button once, the drone will keep
ascending until a height of 30 meters.
If you press the backward button once, the drone will keep
descending autonomously until it is at a height of 5 meters.
You can make it stop at any height when the drone is going up
or down with a tap on the hover button.
Press and hold the follow me button or the take-off button, the
drone will keep rotating right or left as long as you hold the
button.
Orbit Fly
On pressing and holding the orbit fly button, the drone will fly in an orbit
at radius of 5 meters. The orbit will surround a center in front of the
drone. The camera will look at the center all the time.
During orbit fly, press the leftward button once and the orbit will be 0.5
meter smaller. Similarly if the right button is pressed, the orbit will be
0.5 meter larger.
Orbit fly
press and hold
Assembly
5m