- ページ 7

おもちゃ GREAT PLANES avistar eliteのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES avistar elite 20 ページ。

❏

2. Slide the horizontal stabilizer into the stab slot in the aft

end of the fuselage. Push it as far forward as it will ﬁ t. Center

the stab in the slot. Look down through the vertical ﬁ n slot and

ensure that the cutout in the horizontal stabilizer is aligned

with the vertical ﬁ n slot.

❏

3. Fit the vertical ﬁ n into the vertical ﬁ n slot. The metal

posts in the ﬁ n should pass through the holes in the bottom

of the fuselage.

❏

4. Locate the two EasyAlign tail bolts. Slide them into the

holes in the underside of the fuselage and onto the threaded

metal posts. The bolts should be tightened snugly so the tail

section is secure. Conﬁ rm that the horizontal stabilizer and

vertical ﬁ n cannot shift in their slots. Take care not to over-

tighten them as excessive force could damage the nylon

threads and it may cause in-ﬂ ight failure. Do not over tighten

these bolts.

❏

5. Connect the clevis on the elevator pushrod to the second

from the outer hole in the elevator control horn. Slide the

silicone clevis retainer to the end of the clevis.

❏

6. Install the rudder clevis to the outer hole of the rudder

control horn. Slide the silicone clevis retainer to the end of

the clevis.

❏

7. Unstrap the receiver battery holder from the receiver

tray. Disconnect the receiver battery holder from the switch

harness and remove it from the plane.