- ページ 5

おもちゃ GREAT PLANES Big Stir 40のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Big Stir 40 20 ページ。

ページを印刷する

WING ASSEMBLY

❏

1. Locate the left and right aileron. Make a line 3/4"

(19mm) long on the leading edge of the aileron 1-1/2"

(38mm) from each end of the aileron. Make two additional

3/4" (19mm) lines, spacing them equally between the first

two lines.

❏

2. From the 2" x 9" (50mm x 230mm) hinge material, cut

out your hinges. A total of 16 hinges will be needed for the

entire airplane. The hinges need to be cut to 3/4" x 1"

(19mm x 25mm).

CUT HINGE SLOT

WITH HOBBY KNIFE

AND #11 BLADE

❏

3. Cut a 3/4" (19mm) slot in the leading edge of the

aileron at the previously marked locations. Trial fit the hinge

3/4"

DRILL A 3/32" HOLE

1/2" DEEP, IN CENTER

OF HINGE SLOT

to make sure it goes in 1/2" (13mm). The slot can be done

with a hobby knife or the Great Planes Slot Machine

Slot Machine is a real time saver when cutting slots for

hinges. If you are an avid modeler you will find this to be a

great tool to add to you shop!

❏

4. Align the aileron in position at the trailing edge of the

wing. Be sure to leave at least a 1/6" (1.6mm) spacing

between the aileron and the outboard trailing edge of the

wing. When you are satisfied with the fit, mark the location

for the hinges on the trailing edge of the wing. Do this for the

left and right wing.

TEMPORARY PIN

TO KEEP HINGE

CENTERED

❏

5. Install the aileron to the wing by applying 6 drops of

thin CA to the hinge. After the glue has cured, flex the aileron

back and forth a few times to loosen up the hinge. Pull on

the aileron to make sure that the aileron is firmly attached to

the wing. Repeat this step for the other wing.

❏

6. Locate the servo bay in the bottom of each wing and

cut away the MonoKote to reveal the servo tray. Repeat for

the other wing.

. The

™