- ページ 6

おもちゃ Aircraft in Miniature Limited Historic WingsのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Aircraft in Miniature Limited Historic Wings 10 ページ。 1:72 metal kit of the 1906 santos dumont 14 bis

ページを印刷する

E Fold the centre section frame to a square section, then bond the joint to give a

strong joint.

F Fold the four locating lugs on each of the forward and rear engine mounts.

G Attach the engine mounts and engine bearers in position.

H Attach the centre section frame to the fuselage as shown in Figure 4. The

verticals of the centre section frame fit into recesses etched in the outside of

the fuselage longerons (longitudinal members).

REAR ENGINE MOUNT

ENGINE BEARERS

FORWARD

ENGINE MOUNT

3 WING ASSEMBLY

A Remove the upper and lower wings, wing spars, interplane frames and ailerons

from the frets and remove any burrs from the attachment tags.

B Fold all the ribs on each wing through 90°.

C Engage the slots in the wing spars in the slots in the verticals of the centre

section frame. Make sure that they are symmetrical, then bond the wing spars

in place.

D Attach the interplane frames between the right upper and lower wings to form

the right wing assembly as shown in Figure 6 below.

RIGHT WING SHOWN

LEFT WING IS OPPOSITE

Figure 4

Figure 5

INTERPLANE

FRAMES

FUSELAGE

R W

F O

CENTRE SECTION FRAME

WING SPAR TO CENTRE

SECTION FRAME ATTACHMENT

TYPICAL OF 8 PLACES

R W

F O

UPPER WING

AILERON

R W

F O

LOWER WING

A R

WING SPARS

A R