- ページ 9

おもちゃ GREAT PLANES Douglas DC-3のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Douglas DC-3 20 ページ。

directly behind the leading edge of the wing. Pull the wires

out of the center holes using the string as shown in the

above photo. The strings will help you guide the connectors

and wires through the holes in the wing ribs.

Install the Motor Cowls

1. Trim the cowl parts along the cut lines and mount

them into place. You have a number of options to complete

this; the method shown in the photos is to tape the cowls into

place using a clear tape. You can glue them if you wish, or

you can glue one portion such as the bottom half and tape

the remaining pieces. You could also mount them into place

with double-sided tape such as a good quality carpet tape.

2. Assemble the propeller shaft extension, propeller

and the propeller adapter as shown in the above photo.

Place the rubber propeller adapter into the propeller and

press it onto the shaft of the extension. Place the assembly

onto the motor shaft and secure it with two set screws on

each adapter.

Important: The rubber adapter must be placed on the

correct side of the prop. One side of the prop has a raised

flat area as shown in the photo above. The rubber adapter

must be inserted into this side.

1. Assemble the landing gear using the above photos

as a guide. Use (2) landing gear wires, (2) main LG adapters,

(6) 3mm set screws, (1) 3mm x 32mm axle, (2) plastic

spacers and (1) 51.5mm main wheel. Use threadlocker on all

the set screws.