- ページ 8
おもちゃ Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 10 ページ。 1:72 metal kit
ページを印刷する(8) Use a hair frier of similar appliance to blow warm air over the film to tighten it.
(8) Use a hair frier of similar appliance to blow warm air over the film to tighten it.
(9) Apply the 'BOXKITE' decals to the outboard face of each rear rudder.
(9) Apply the 'BOXKITE' decals to the outboard face of each rear rudder.
6 LANDING GEAR AND DETAIL PARTS ASSEMBLY (See Figure 9)
6 LANDING GEAR AND DETAIL PARTS ASSEMBLY (See Figure 9)
A Remove these components from the frets and remove any burrs from the
A Remove these components from the frets and remove any burrs from the
attachment tags:
attachment tags:
-
-
Control column
Control column
-
-
Foot rest
Foot rest
-
-
Fuel and oil tank supports
Fuel and oil tank supports
-
-
Propeller shaft mounting
Propeller shaft mounting
-
-
Seat
Seat
B Assemble the seat.
B Assemble the seat.
(1) Fold the seat, and foot rest, bond /solder them together, then attach the control
(1) Fold the seat, and foot rest, bond /solder them together, then attach the control
column, as shown in Figure 7 below.
column, as shown in Figure 7 below.
(2) If required, paint the assembly to resemble wood.
(2) If required, paint the assembly to resemble wood.
FOOT REST
FOOT REST
C Fuel and oil tanks
C Fuel and oil tanks
(1) Fold the fuel and oil tank supports as shown in Figure 8 below.
(1) Fold the fuel and oil tank supports as shown in Figure 8 below.
(2) Remove any casting seams or flash from the cast metal fuel and oil tanks.
(2) Remove any casting seams or flash from the cast metal fuel and oil tanks.
(3) Attach the two tanks as shown in Figure 8 below.
(3) Attach the two tanks as shown in Figure 8 below.
(2) If required, paint the assembly:
(2) If required, paint the assembly:
-
-
The tanks are brass
The tanks are brass
-
-
The supports are steel
The supports are steel
-
-
Paint the base to resemble wood.
Paint the base to resemble wood.
D Engine, propeller and drive shaft:
D Engine, propeller and drive shaft:
(1) Drill 0.75mm/.03" diameter holes through the hub of the propeller hub and the
(1) Drill 0.75mm/.03" diameter holes through the hub of the propeller hub and the
engine.
engine.
(2) Attach the propeller to the engine with 5-minute epoxy adhesive.
(2) Attach the propeller to the engine with 5-minute epoxy adhesive.
(3) Put a pin or a piece of wire (make sure the wire is straight) through the
(3) Put a pin or a piece of wire (make sure the wire is straight) through the
propeller/engine assembly and attach it to the propeller shaft mount with 5-
propeller/engine assembly and attach it to the propeller shaft mount with 5-
minute epoxy adhesive.
minute epoxy adhesive.
CONTROL
CONTROL
COLUMN
COLUMN
SEAT
SEAT
Figure 7
Figure 7
Figure 8
Figure 8