- ページ 6

おもちゃ GREAT PLANES ElectroStik ARFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES ElectroStik ARF 20 ページ。

PREPARATIONS

Use a covering iron with a covering sock on medium/high heat

to tighten any loose covering if necessary. Apply pressure over

sheeted areas to thoroughly bond the covering to the wood.

❏

1. Install the 20-7/8" [530mm] carbon ﬁ ber wing joiner

tube and the 1" [25.4mm] steel alignment pin into the right

wing panel as shown.

❏

2. Carefully slide the left wing panel in place as shown.

❏

3. Fasten the wing halves together using the two included

nylon straps and four #2 x 3/8" [9.5mm] self-tapping screws

as shown.

❏

4. Install the rubber grommets and eyelets that were

included with the servo and place it in the aileron servo tray

as shown. Note: You may need to use a bent paper clip to

pull the servo connector out of the wing.

❏

5. Drill a 1/16" [1.6mm] hole through each mounting

hole location. Do not drill all the way through the wing;

the holes should be just deep enough to accommodate the

length of the servo mounting screws.

❏

6. Install the servo into the aileron servo bay using the

servo mounting screws that came with your servos, with the

servo spline toward the front of the wing.

6 6