- ページ 6

おもちゃ GREAT PLANES EXTRA 330SCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES EXTRA 330SC 20 ページ。 Model aircraft great planes extra 330sc

❏

7. Test ﬁ t the #1 and #3 bottom crutches over their

corresponding top crutches. Install the ABS motor mount

onto the front of the ﬁ rewall, but DO NOT glue it in place

at this time. Check that all the crutches are seated against

the fuselage and the horizontal and vertical fuselages are

keyed together. Then, glue the top and bottom of crutches

#1 and #3 together by applying a small amount of foam safe

CA to the tabs of the crutches. Be careful to not glue the

crutches to the fuselage.

❏

8. Position the two wing tip crutches under the wing tips at

the counter balance joint and the bottom crutches #2 and #4

over the carbon ﬁ ber strip in the wing and stabilizer.

❏

9. Make sure the horizontal and vertical fuselages are

keyed together and the crutches are ﬂ at on your building

table. Glue the horizontal and vertical fuselages together by

applying thin foam safe CA along the joint on the bottom

of the horizontal and vertical fuselages. Be careful when

gluing around the crutches. DO NOT glue the crutches to

the fuselage. Allow the CA to cure for a few minutes before

moving the plane. The use of foam safe accelerator will

quicken the curing of the CA, but use it sparingly. Excessive

amounts of accelerator can cause the CA to cure quickly,

causing it to get hot and melt the foam.

❏

10. Carefully turn the Extra 330SC over and position the

bottom crutches #2 and #4 under the carbon ﬁ ber strips in

the wing and stabilizer. Check that the crutches are ﬂ at on

the building table and the horizontal and vertical fuselages

are keyed together. Use thin foam safe CA to glue the top of

the horizontal and vertical fuselages together.

❏

11. Turn the plane back over so that it is sitting upside

down. Locate the two ABS brace supports. There is a slot

located in the center of each wing. Glue the ABS brace

supports into the slots, perpendicular to the underside of the

wing. It is possible that, during manufacturing, some glue

may have gotten into the slot. If this has happened, DO NOT

FORCE the supports into the slot. Use a sharp hobby knife

to remove any excess glue.