- ページ 7

おもちゃ GREAT PLANES FLINGのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES FLING 16 ページ。 Fling arf

6. Glue the carbon fiber wing dowels into the fuse with

a small amount of thin CA.

Assemble the Tail

1. Remove the covering from the control horn slots in the

rudder and elevator.

2. Use a small square and a single-edge razor blade or

a #11 hobby blade to cut a strip of covering from the bottom

and top of the stab aligned with the fin slot and

perpendicular to the hinge line. Use a light touch to cut only

into the covering and not into the wood. Also be sure to

use a new blade–if the blade is dull it will cause you to apply

more pressure, thus cutting into the wood.

3. Glue the fin to the top of the stab, keeping it vertical

and perpendicular to the elevator hinge line. Note: The

elevator hinge pivot is on the top of the stab.

1. Mount the wing to the fuse with the four rubber bands.

2. Move the tape holding the pushrod strings forward of

the pushrod exits. This will minimize the chance of gluing the

pushrod strings to the fuse while gluing the tail in place.

3. Three things need to be aligned before the tail can be

mounted. Do several dry runs of this process before gluing

the tail to the fuse with medium CA.

4. The center of the fin needs to be aligned with the

center of the fuse.