- ページ 10

おもちゃ GREAT PLANES GitabriaのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Gitabria 20 ページ。 Electrifly series

❏

2. Connect the elevator servo to your receiver. Remove the

servo screw from the servo and install a large servo arm onto

the servo. Center the trims on the transmitter. Position the

servo arm so that one arm is perpendicular to the centerline

of the servo as shown. Use diagonal pliers to remove the

three extra servo arms.

❏

3. Install the elevator servo in the forward servo hole with

the output shaft towards the front of the fuselage. Glue the

servo in place with foam-safe CA. Be careful not to get any

glue inside the servo case.

❏

4. Center the servo arm on the rudder servo and trim off

the extra servo arms. Use foam-safe CA to glue the rudder

servo, with the output shaft forward, in the aft servo hole on

the left side of the fuselage.

❏

5. Install the pre-assembled elevator pushrod by inserting

the ABS pushrod guides through the fuselage as shown. DO

NOT glue the pushrod guides in place at this time.

❏

6. Insert the rudder pushrod from the front, through the

ﬁ ve pushrod guides. The z-bend should be next to the rudder

servo arm.

❏

7. Remove the elevator servo arm and insert the z-bend

into the outer hole of the arm, approximately 5/8" [16mm]

from the center of the servo arm. Note: If you are not using

a computer radio, and do not wish to set your model up with

3D control throws, you will need to insert the z-bend in a hole

closer to the center of the servo arm. The z-bend should be

installed so that the pushrod is on the back side of the servo