- ページ 15

おもちゃ GREAT PLANES GitabriaのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Gitabria 20 ページ。 Electrifly series

ページを印刷する

❏

4. Apply the remaining hook and loop material to the bottom

of the horizontal fuselage at the approximate location for the

motor battery. Attach an opposite piece of hook and loop

material to the battery. Trial ﬁ t the motor battery to the bottom

of the fuselage and recheck the C.G.

GET THE MODEL READY TO FLY

Check the Control Directions

❏

1. Remove the propeller and switch on the

transmitter and connect the motor battery.

all the control surfaces to see if they are centered.

4-CHANNEL RADIO SET UP

RUDDER

MOVES

RIGHT

FULL

THROTTLE

❏

2. Make certain that the control surfaces respond in the

correct direction as shown in the diagram. If any of the controls

respond in the wrong direction, use the servo reversing in the

transmitter to reverse the servos connected to those controls.

Be certain the control surfaces have remained centered. Adjust

if necessary.

Check

(STANDARD MODE 2)

RIGHT AILERON

MOVES UP

LEFT AILERON

MOVES DOWN

ELEVATOR

MOVES DOWN

Set the Control Throws

To ensure a successful ﬁ rst ﬂ ight, set up your Citabria 3D

according to the control throws speciﬁ ed in this manual.

The throws have been determined through actual ﬂ ight

testing and accurate record-keeping, allowing the model

to perform in the manner in which it was intended. If, after

you have become accustomed to the way the Citabria

3D ﬂ ies, you would like to change the throws to suit your

taste, that is ﬁ ne. However, too much control throw could

make the model too responsive and difﬁ cult to control, so

remember, "more is not always better."

❏

1. Use a box or something similar to prop up the bottom

of the fuselage so the horizontal stabilizer and wing will

be level.

❏

2. Measure the 3D elevator throw ﬁ rst. Hold a ruler vertically

on your workbench against the widest part (front to back) of

the trailing edge of the elevator. Note the measurement on

the ruler.

❏

3. Move the elevator up with your transmitter and move

the ruler forward so it will remain contacting the trailing

edge. The distance the elevator moves up from center is

the "up" elevator throw. Measure the down elevator throw

the same way.

❏

4. Measure and set the high and low rate elevator throws

and the high, low, and 3D rate throws for the rest of the control

surfaces the same way.

If your radio does not have dual rates, we recommend

setting the throws at the high rate settings.

NOTE: The throws are measured at the widest part of

the elevators, rudder and ailerons.