- ページ 9

おもちゃ GREAT PLANES Piper j-3 cubのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Piper j-3 cub 16 ページ。 Electrifly series
GREAT PLANES Piper j-3 cub にも：取扱説明書 (6 ページ)

ページを印刷する

Install the Horizontal Stabilizer & Rudder

❏

1. Draw a line on the center of the top and bottom of the

horizontal stabilizer. The top of stab has the control horn

slot on the right side of the elevator.

❏

2. Lightly scuff the surface of the stab using sandpaper 5/64"

[2mm] on both sides of the line drawn in step 1. Wipe the area

with denatured alcohol. Do this on both the top and bottom of the

stab. Position the stab onto the back of the fuselage. Using the

line drawn in step 1 as a reference, position the stab making

sure the stab is parallel to the wing. When you are satisfied with

the fit, glue the stab to the fuselage.

❏

3. Glue the vertical stabilizer/rudder into the slot in the

fuselage and the top of the horizontal stabilizer. Hold it in

place until the glue hardens.

Install the Tail Servos & Linkages

❏

1. Glue the rudder and elevator servos into the cutout in

the fuselage with the output splines both facing the front of

the plane. The servo in the bottom of the slot is the rudder

servo and should be installed with the splines on the left

side of the fuselage. The servo in the top of the slot is the

elevator servo and should be installed with the splines on

the right side of the fuselage. Both servo leads should exit

out of the right side. There is a small circle cutout in the

fuselage to allow the lead from the elevator servo to get

access to the right side of the fuselage.

❏

2. Using the same technique used for the ailerons, install

a control horn onto the left side of the rudder and one on the

bottom of the right elevator half.

❏

3. Use your radio system to center the elevator and

rudder servos. Cut three arms from two four-arm servo

horns and install them onto the elevator and rudder servos,

both pointing downward. Enlarge the outer holes of the

servo horns with a 3/64" [1.2mm] drill bit. Enlarge the inner

hole of the control horns (closest to the elevator and rudder)

with the same size bit.